S10 transmission mount for Turbo 350 or 400 transmission when swapping out the original . Will fit factory crossmember. Learn More

This item is for the conversion radiator in the standard location which is on the back side or rear of the radiator support. Also need are the rubber insulators which are Not part of this kit. These are the top brackets only. Learn More

These plates will center the rear end in the wheel wells also may eliminate the need to shorten the drive shaft. The plates set the rear end back and stock u-bolts will work. Learn More

Pair of 2.8 Frame Mounts (needed if truck came with other than 2.8 motor) Learn More

Turns fan on/off at the desired temperature. Dial-adjustable 1800-2400F. Gives the freedom to set one temperature for occasional high-demand use, then reset for highway or day-to-day driving Learn More

Radiator brackets fit early S10 when radiator is installed in the front mount postion. Please note some modifications are needed. Learn More

Stealth S10 V8 conversion manual Chevrolet V-8 into 1982-1993 Chevrolet S-10 trucks. This book also contains a short chapter on the V-8 swap into the New Body Style. Learn More

MADE IN USA Motor mounts for installing a small block Chevy V8 in your 2 wheel drive S10 truck, HD Steel construction. These S10 V8 swap mounts allow maximum adjustment of engine placement. These are proven to fit, THE BEST ON THE MARKET! ADAPTS TO 2.8L RUBBER FRAME MOUNTS ONLY, IF YOU HAVE A 2.2L, 2.5L OR 4.3L ORIGINALLY. YOU WILL NEED TO PURCHASE THEM WE SELL THEM FOR $28.00 A PAIR.. SEE #ssiA2435 http://s10v8.carshopinc.com/product_info.php/products_id/61/SSIA2435 MADE IN USA Learn More

This regulator is ready to install and is designed to be used with the factory in tank fuel pump. Regulator is a bypass style and is adjustable. Learn More

Motor mounts for installing a small block Chevy V8 in your 4 wheel drive S10 truck, HD Steel construction. These S10 V8 swap mounts allow maximum adjustment of engine placement. These are proven to fit, THE BEST ON THE MARKET! Learn More

MADE IN THE USA MOLINE IL New item finally a S10 frame mount that will handle higher horse power SBC V8. The mount has polyurethane bushing which will have some give so the vehicle can be driven on the street. Works together with our 2 wheel or 4 wheel drive V8 conversion engine brackets Learn More

LS1 S10 2WD V8 MOUNTS The First step in installing the LS1 engine into your S10. Fits all years of the s-10 S-15 Sonoma Blazer Jimmy chassis. Mounts are slotted so you can position the engine to your needs. 2 wheel drive only! Learn More

Solid steel frame mounts. This item replaces the factory rubber frame mounts. This is a must for Drag racing and will eliminate engine movement. These mounts should not be used on a street driven vehicle Learn More

S-10, S-15, V8 2-Wheel Drive Conversion Motor Mounts with Rubber Frame Mounts CSP2345 S10 V8 Conversion Motor Mounts 2 Wheel Drive Designed for 2 wheel drives only s10 to Chevy small block v8 engine mounts. This is the best mount on the market. This allows maximum adjustment for engine placement. Also comes with the rubber frame mounts Learn More

Complete LS S10 two wheel drive kit with both the steel and rubber mounts Learn More