MSD IGNITION #6425 6AL Ignition Control Box
DIGITAL 6AL IGNITION CONTROL BOXFeatures
- With Soft Touch Rev Control
- Higher output with 530 primary volts and 135mJ of spark energy
- Efficient components use less current to produce more power
- Set an rpm limit on the 6AL with two rotary dials
- Same bolt pattern as the original 6AL with a lower profile housing
- Built-in LED for system checks
- All wires exit the same side through a locked, sealed connector
- Compatible for 4, 6 or 8-cylinder engines
The MSD 6AL Ignition Control set the standards that other ignitions strive to reach. In fact, youll find ignitions from other companies that carry the 6AL name (and in some cases, the same part number). For 2011, the bar has been raised even higher as we introduce the all new Digital 6AL Ignition Control!
MSD started with a clean slate and drew up plans for an all new housing. We kept the same footprint as the traditional 6AL but lowered the profile for a sleek look. The wiring is all routed out one end of the unit through a sealed and locking connector. This eases installation and keeps your wiring looking neat and clean. The rev limiter was moved right on top of the housing for easy access to the two rotary dials to set the limit in 100 rpm increments.
Inside the Digital 6AL youll find a microprocessor that monitors and controls every firing and rev limit. The circuits are updated with efficient components that help the ignition produce more power while drawing less current! In fact, the new Digital 6AL delivers over 530 volts to the coil with up to 135mJ of spark energy for every firing! Increased output combined with MSDs proven multiple spark series is a win-win situation!
The new Digital 6AL are supplied with the wiring harness and the components youll need for installation. The 6AL is also supplied with vibration mounts. Both ignitions are compatible on 4, 6 or 8-cylinder engines with 12-volt, negative ground electrical systems. Theyll accept trigger inputs from breaker points, amplifiers and magnetic pickups.
|Spark Energy:||135-145 mJ per spark|
|Primary Voltage:||520-540 Volts|
|Secondary Voltage:||45,000 Volts|
|Spark Series Duration:||20 degree Crankshaft Rotation|
|RPM Range:||15,000 RPM with 14.4 Volts|
|Voltage Required:||12-15 Volts, 7 Volt Start|
|Current Draw:||.7 Amp per 1,000 RPM|
|Weight and Size||1.7 lbs., 8"L x 4"W x 1.825"H|
|Truck Freight Only||NO|
|Warnings||These products may contain a chemical known to the state of California to cause cancer and birth defects or other reproductive harm|